Tutorial

Directions

Roll the pen in green Duck Tape

Step 1

Place your pen on the outside edge of a strip of Duck Tape® and roll the pen across to cover.

22-30 squares of brown Duck Tape

Step 2

For the center of the flower, cut out several squares of Duck Tape® measuring 2 in. each. You will need about 22-30.

squares from previous step with the top two corners folded to the center to form a double sided triangle with a sticky rectangle sticking out the bottom

Step 3

Sticky side up, fold each edge over itself, leaving only stickiness on the bottom of the squares.

Pieces from the previous step overlapped and rolled onto the top of the pen to form the center of the flower

Step 4

Roll the pieces from step 3 around the top edge of the pen creating the center of the flower. Set this aside.

Strip of pink Duck Tape cut down the middle

Step 5

For the flower petals, cut eight pieces of Duck Tape® that are 5 in. long and 1 in. wide.

floral wire that is nearly half the length of the strip placed in the center of the strip from the previous step

Step 6

Using wire cutters, cut a 3 in. piece of floral wire and place the wire toward the end of your tape strips from step 5.

Fold the excess tape over the wire so that most of the wire is covered, but there is a small amount of wire and sticky side of the tape sticking out the bottom

Step 7

Fold the top of the tape over, leaving the bottom half of the petal with the sticky side of the tape exposed.

Trim the piece from the previous step into a daisy petal shape

Step 8

Cut the folded side of the tape strip into a flower petal shape.

wrap the petal from the previous step around the center of the flower that was made previously

Step 9

Take your petals and place the side with the adhesive showing on the stem and wrap the edges around it.

Steps 6-10 repeated until there are 8 petals wrapped around the flower's center

Step 10

Repeat steps 6-10 until you have a total of eight petals.

small strips of Duck Tape wrapped around the base of the flower where the petals are taped to the pen

Step 11

Cut a 2 in. piece of Duck Tape® and cut four squares out of it. Place each of the squares at the base of the flower for a clean finish.